Benincà SR2.60SE Rolling Shutter Operator, 230 V, with Brake, up to 320 kg

Overview

The Benincà SR2.60SE is a 230 V AC electromechanical operator for balanced rolling shutters, from the SUPERBE range made by the Benincà group under its CAB brand. It has two motors, an aluminium crown gear and the SRE.X2 electric brake, which holds the shutter when the motors stop.

Is it right for you?

It suits shops, garages and warehouses with a heavier balanced rolling shutter of up to 320 kg and 32 m², with up to 8 m of travel. For a lighter shutter, look at the SR1.60E (up to 170 kg).

Key features

• 230 V AC, 50/60 Hz, maximum current 5.4 A
• Maximum torque 320 Nm
• SRE.X2 electric brake fitted
• Automatic limit switch that learns the open and closed positions
• Technopolymer flange that spreads the load from the shutter
• Fits a 60 mm shutter shaft, or a 42 or 48 mm shaft with the KSR60.42 or KSR60.48 kit
• For 200 or 220 mm pulleys

What else you need

• A 230 V AC control unit such as the DREAMY
• A KSR60.48 reduction kit if the shutter shaft is 48 mm
• A BL.BS control and release unit, so the shutter can be moved by hand in a power cut
• Remotes that work with the control unit’s receiver

Installation

The motor goes inside the shutter tube: a hole is drilled through the tube, the motor is slid in and then fixed. A trained installer should fit it and set it up.

Before you buy

• Protection rating IPX0, so the motor must be fitted where it is sheltered from water.
• The 4 m motor cable comes with the SR2.60SEC version, not with the SR2.60SE.