UGREEN 20714 10 m 3-Pin XLR Male-to-Female Cable

Overview

A microphone on a stage, in a hall or across a large room needs a long balanced cable to reach the mixer or PA without picking up noise. The UGREEN 20714 is a 10 m three-pin XLR male-to-female cable with a locking female connector, copper shielding and metal shells. It carries microphone or line-level balanced audio and passes phantom power supplied by the mixer or interface.

Is it right for you?

• Suits dynamic microphones, and condenser microphones in a phantom-powered chain where the mixer or interface supplies the power.
• Suits mixers, audio interfaces, microphone preamps, recorders and cameras with full-size three-pin XLR ports, and powered speakers, studio monitors and processors with balanced XLR line connections.
• 10 m suits stages, halls and larger rooms. For a microphone next to the mixer, a shorter cable is easier to manage.
• Not for mini-XLR, 4-pin or 5-pin XLR, 6.35 mm, 3.5 mm, RCA, USB, speakON or optical ports, and not specified for DMX lighting control, AES3 digital audio or passive speaker power.

Key features

• Full-size three-pin XLR male at one end and locking XLR female at the other, which helps prevent accidental separation from a latched source.
• Copper conductors with insulation, internal filler and copper shielding to reduce interference pickup along the run.
• Flexible outer jacket and metal connector shells.
• Passes phantom power supplied by suitable equipment through a correctly wired XLR chain; it has no power source of its own.
• Passive, with no gain, conversion or electronics.

What else you need

Balanced XLR equipment at both ends with compatible levels and wiring. Phantom power, when needed, comes from the mixer, interface, recorder or a separate supply.

Before you buy

• Confirm that the microphone and every connected device tolerate the selected phantom-power setting. Turn phantom power off and let the circuit discharge before changing connections, and keep speaker and headphone levels low during power-up.
• It does not generate phantom power, microphone gain, line gain or headphone volume, and it cannot remove hum, clipping, radio interference or noise created elsewhere in the system.
• It does not change pin count or connector gender beyond the ends fitted, and it does not convert analogue audio to USB, HDMI, optical or Bluetooth.
• A 10 m run across a floor is a trip hazard. Secure floor crossings with cable covers or another venue-approved method.
• Remove the cable from service if a pin is bent, loose or corroded: a damaged pin can short contacts or cause intermittent audio. It is for low-level audio only, not amplifier speaker outputs or electrical power.