ZKTeco FBL220 Flap Barrier

Overview

The ZKTeco FBL220 is the extra lane cabinet for the FBL200 flap barrier. When one lane is not enough at a busy office lobby, factory gate or campus entrance, you place an FBL220 beside the FBL200 to get a second controlled lane, and add further FBL220 units for a third, fourth or more. Each lane opens for one person at a time once a reader accepts a valid card or fingerprint.

It is built to match the FBL200: a SUS304 stainless steel cabinet and lid with clear acrylic flaps that retract into the cabinet when the lane opens.

Is it right for you?

• Suits an entrance that already has, or is being fitted with, an FBL200 and needs several matching lanes for peak arrival times.
• It cannot form a lane on its own. For a single lane, order the FBL200 instead.
• It is a medium security barrier, so it suits staffed or camera-monitored entrances rather than unattended perimeters, where a full height turnstile is the better choice.
• It can be used outdoors only under shelter.

Key features

• Up to 30 people per minute per lane, with an opening time of 0.8 s, so queues clear quickly at the start of a shift.
• 570 mm lane width, with a cabinet of 1,200 x 300 x 980 mm.
• Retracting acrylic flaps in a SUS304 stainless steel cabinet and lid, the same construction as the FBL200.
• Opening noise of 30 dB or less, quiet enough for a reception area.
• Emergency mode retracts the flaps to clear the lane, and LED indicators show which way the lane is open.
• Runs on 100 to 120 V or 200 to 240 V AC at 50 or 60 Hz, and works from -28 to 60 °C at 5 to 80% humidity, non-condensing.

What else you need

An FBL200 as the end cabinet of the line, since the FBL220 is an add-on unit. For an entrance with several lanes, the usual arrangement is one FBL200 plus one FBL220 for each extra lane.

A Radio Frequency Identification (RFID) card or fingerprint reader for each lane, an access controller or management software to hold the user list, and mains power to every cabinet.

Installation

A turnstile installer should fit it. The job involves fixing each cabinet to a level floor, running power and reader cabling to every cabinet, usually through floor ducts, and setting the lane direction and reader logic with the controller.

Before you buy

• Confirm the number of lanes and the cabinet layout with us before ordering, so the right mix of FBL200 and FBL220 units is supplied.
• Outdoor use needs shelter from rain and direct weather.