Nice Run RUN2500 Sliding Gate Kit, up to 2500 kg

Overview

The Nice Run kit (RUN2500) automates a heavy sliding gate of up to 2500 kg, built for intensive use and demanding conditions at a business, industrial or large residential entrance. The RUN2500 is a non-reversible gearmotor powered at 230 to 250 V AC with an integrated control unit and an electromechanical limit switch, with accessories connected over Nice BlueBUS. The kit adds a plug-in two-way radio receiver, two remotes and a pair of BlueBUS photocells.

Is it right for you?

• It suits a sliding gate weighing up to 2500 kg; check the gate weight before ordering.
• It is rated for 42 cycles per hour and built for intensive use, so it suits an entrance that opens often through the day.
• At 0.17 m/s it is a steady gearmotor for a very heavy gate rather than a fast one.
• The kit has no flashing light, so plan to add one.
• The gearmotor is IP44 rated and works from -20 to 50 °C, so it is made for fitting beside the gate outdoors.

Key features

• 230 to 250 V AC, 50 Hz motor drawing 3.8 A and 870 W.
• 1390 N of force for moving a very heavy gate, at 0.17 m/s.
• Non-reversible gearmotor with an electromechanical limit switch, so the gate stops in the right place at each end of its travel.
• Integrated control unit with accessories connected over Nice BlueBUS on two wires.
• OXIBD plug-in bidirectional radio receiver for two-way remotes.
• Two ON2E two-channel 433.92 MHz remotes and an EPMB surface-mounted BlueBUS photocell pair.
• Gearmotor 400 x 255 x 390 mm and 24.5 kg, IP44, -20 to 50 °C.

What else you need

• A rack for the full length of the gate travel; the rack is not included. The gearmotor comes with a module 4 crown for the galvanised ROA7 or ROA8 rack; for the heavier ROA81 module 6 weld-on rack, add the RUA12 crown.
• A flashing light: the ELAC, the mains-voltage flashing light matched to this control unit.
• A 230 to 250 V AC, 50 Hz mains supply at the gate.

Installation

A gate automation installer should fit it. The job involves fixing the 24.5 kg gearmotor on a base beside the gate, bringing the mains supply to it, fitting the rack along the gate leaf with the matching crown, setting the limit switch, wiring the BlueBUS photocells and the flashing light to the control unit, and programming the remotes into the OXIBD receiver.

Before you buy

• The rack is not included. The Run is supplied with a module 4 crown for the galvanised ROA7 or ROA8 rack; for the ROA81 module 6 weld-on rack, add the RUA12 crown. Order rack for the full length of the gate travel.
• No flashing light is supplied: add the ELAC, the mains-voltage flashing light matched to this control unit.
• Kit contents are as supplied and are confirmed when you order.