Nice Tub TUB4000 Industrial Sliding Gate Kit, up to 4000 kg, 400 V

Overview

The Nice Tub kit (TUB4000) automates a large industrial sliding gate of up to 4000 kg, so a factory, warehouse or depot gate opens and closes from a remote. The TUB4000 is a non-reversible 400 V AC electromechanical gearmotor with a built-in D-PRO 500 control unit, an electromechanical brake, a self-ventilated motor, metal and bronze gears and a lever release. The kit adds a plug-in two-way radio receiver, a pair of photocells and two remotes.

Is it right for you?

• It suits an industrial sliding gate weighing up to 4000 kg; check the gate weight before ordering.
• It needs a 400 V AC, 50 Hz supply at the gate, so confirm that this is available before ordering.
• It is rated for 42 cycles per hour with leaves up to 5 m, so it suits an entrance that opens often through the working day.
• The gearmotor is IP54 rated and works from -20 to 50 °C, so it is made for fitting beside the gate outdoors.

Key features

• 400 V AC, 50 Hz motor drawing 1.6 A and 580 W, with 7740 N of force for a very heavy gate.
• Moves the gate at 0.16 m/s.
• Built-in D-PRO 500 control unit and an electromechanical brake, so the gate stops firmly.
• Self-ventilated motor with metal and bronze gears, built for intensive industrial use.
• Lever release lets the gate be freed and moved by hand.
• OXIBD plug-in bidirectional radio receiver, two INTI2 two-channel 433.92 MHz remotes and an EPM surface-mounted photocell pair.
• Gearmotor 480 x 240 x 580 mm and 60 kg, IP54, -20 to 50 °C.

What else you need

• A 400 V AC, 50 Hz supply at the gate.
• A module 6 rack for the full length of the gate travel, such as the galvanised weld-on ROA81; the rack is not included.
• A flashing light if you want one: the control unit works with the ELAC.
• The control unit also works with OXILR receivers, ERA INTI, ERA ONE / MYGO, MYGOBD and ERA ONE LR remotes, EPS, EPM and EPL photocells, the EPMOR reflective photocell and F210 and FT210 safety devices.

Installation

A gate automation installer should fit it, with the 400 V AC connection made by a qualified electrician. The job involves setting the 60 kg gearmotor on a foundation beside the gate, fitting the module 6 rack along the gate leaf, wiring the photocells and any flashing light to the D-PRO 500 control unit, and programming the remotes into the OXIBD receiver.

Before you buy

• The gearmotor needs a 400 V AC supply at 50 Hz; confirm that this is available on site before ordering.
• The rack is not included: order a module 6 rack such as the galvanised weld-on ROA81 for the full length of the gate travel.
• No flashing light is supplied.
• The gearmotor can also run at 60 Hz with a corresponding change in performance.
• Kit contents are as supplied and are confirmed when you order.