UGREEN 60312 25 m HDMI 2.1 Fibre Cable, 8K60/4K120

Overview

The UGREEN 60312 is a 25 m HDMI 2.1 cable that sends the signal over optical fibre instead of copper, so it can run from a console, PC, media player or AV receiver to a projector, wall-mounted TV or meeting room screen far across the room. It carries up to 48 Gbps, enough for 8K at 60 Hz or 4K at 120 Hz when the source, the display and anything between them support those modes. It is directional: the plug marked Source goes to the sending device and the plug marked Display goes to the screen.

Is it right for you?

• It suits a run where a passive copper HDMI cable would be too short: the route must genuinely need 25 m, with enough slack but no tight coil or tension.
• Because it is directional, you need to know which device sends and which receives before pulling the cable through a wall or ceiling.
• Both HDMI ports must support the mode you want. The cable cannot add a resolution, refresh rate, eARC or an HDCP version to a port that lacks it, and earlier HDMI equipment works at its own lower mode.
• Every adapter, receiver, switch, splitter, wall plate or extra cable in the path must support the same video, HDCP and audio requirements.
• At 25 m, orientation, bend protection and a test before the route is closed matter even more; the cable cannot override the source or display limits.

Key features

• 48 Gbps HDMI 2.1 bandwidth, for up to 8K at 60 Hz or 4K at 120 Hz on supporting equipment.
• HDR10 signalling and Dolby Vision (high dynamic range) pass through for brighter, higher-contrast pictures from compatible content.
• Enhanced audio return channel (eARC), so a TV can send full surround sound back to a soundbar or receiver when the correct labelled ports and direction are used.
• Fibre transmission over the full 25 m, with zinc alloy connector housings and a flexible PVC-covered cable body.
• Active electronics powered from the HDMI ports: no separate power adapter.

What else you need

A source with a full-size HDMI output and a display, projector or receiver with a full-size HDMI input. The active electronics are powered through the HDMI ports, so no separate power adapter is needed, and there is no driver or software to install. It does not convert USB-C, DisplayPort, Mini HDMI, Micro HDMI, DVI or VGA.

Installation

For a run through walls, ceilings or conduit, an AV installer should fit it. The job is to confirm the Source and Display ends before routing, pull the cable along a route with gentle curves and no crushing, plug the Source end into the HDMI output and the Display end into the HDMI input, and test the picture and sound at the intended resolution before the route is closed up. For a run along a skirting or behind furniture, you can plug it in yourself, keeping the direction right.

Before you buy

• The 8K at 60 Hz and 4K at 120 Hz figures are cable ceilings, not guaranteed modes. The source, display, content, firmware and settings decide what you actually get.
• It does not work in reverse. If the Source and Display ends are swapped there will be no picture.
• It is not a passive copper cable: it cannot be cut, shortened or re-terminated, and it does not upscale content, create HDR, decode audio or generate frames.
• No in-wall or concealed-route safety rating is stated for this cable, so do not rely on one.
• Check that the cable you receive is marked 60312 and 25 m.