UGREEN 80407 15 m HDMI 2.1 Fibre Cable, 8K60/4K120

Overview

The UGREEN 80407 is a 15 m HDMI 2.1 cable that sends the signal over optical fibre instead of copper, so it can run from a console, PC, media player or AV receiver to a projector, wall-mounted TV or meeting room screen far across the room. It carries up to 48 Gbps, enough for 8K at 60 Hz or 4K at 120 Hz when the source, the display and anything between them support those modes. It is directional: the plug marked Source goes to the sending device and the plug marked Display goes to the screen.

Is it right for you?

• It suits a run where a passive copper HDMI cable would be too short: the route must genuinely need 15 m, with enough slack but no tight coil or tension.
• Because it is directional, you need to know which device sends and which receives before pulling the cable through a wall or ceiling.
• Both HDMI ports must support the mode you want. The cable cannot add a resolution, refresh rate, eARC or an HDCP version to a port that lacks it, and earlier HDMI equipment works at its own lower mode.
• Every adapter, receiver, switch, splitter, wall plate or extra cable in the path must support the same video, HDCP and audio requirements.
• Keep the connector orientation clear end to end while routing, so the Source plug ends up at the sending device.

Key features

• 48 Gbps HDMI 2.1 bandwidth, for up to 8K at 60 Hz or 4K at 120 Hz on supporting equipment.
• Passes Dynamic HDR, HDR10 and Dolby Vision (high dynamic range) for brighter, higher-contrast pictures from compatible content.
• Variable refresh rate (VRR) passes through for smoother gaming when the console or PC and the display support it.
• Enhanced audio return channel (eARC), so a TV can send full surround sound back to a soundbar or receiver that supports it.
• Low-power active optical transmission over the full 15 m, powered through the HDMI ports with no separate adapter.
• Flexible black TPE-coated jacket suited to a long run.

What else you need

A source with a full-size HDMI output and a display, projector or receiver with a full-size HDMI input. The active electronics are powered through the HDMI ports, so no separate power adapter is needed, and there is no driver or software to install. It does not convert USB-C, DisplayPort, Mini HDMI, Micro HDMI, DVI or VGA.

Installation

For a run through walls, ceilings or conduit, an AV installer should fit it. The job is to confirm the Source and Display ends before routing, pull the cable along a route with gentle curves and no crushing, plug the Source end into the HDMI output and the Display end into the HDMI input, and test the picture and sound at the intended resolution before the route is closed up. For a run along a skirting or behind furniture, you can plug it in yourself, keeping the direction right.

Before you buy

• The 8K at 60 Hz and 4K at 120 Hz figures are cable ceilings, not guaranteed modes. The source, display, content, firmware and settings decide what you actually get.
• It does not work in reverse. If the Source and Display ends are swapped there will be no picture.
• It is not a passive copper cable: it cannot be cut, shortened or re-terminated, and it does not upscale content, create HDR, decode audio or generate frames.
• No in-wall or concealed-route safety rating is stated for this cable, so do not rely on one.
• Check that the cable you receive is marked 80407 and 15 m.