ZKTeco RC10 Wireless Remote Exit Button Set, 433.92 MHz

Overview

The ZKTeco RC10 is a wireless door release: a small receiver with one relay at the door and a metal key fob that opens it from up to 30 m away. It solves the problem of a door that needs a release where there is no practical route for a cable, through a glass entrance, across a finished lobby or into a listed wall. One receiver learns up to 30 fobs, and one metal fob comes with it.

Is it right for you?

• It suits a reception desk or shop counter that needs to buzz visitors in without wiring a button.
• Latch mode holds the door unlocked until pressed again, so a shop or clinic can leave the entrance free during opening hours without changing the access schedule.
• It is a convenience device, not an emergency one: on a fire escape route it should add to, not replace, a wired exit button and break glass unit, since the fob depends on a battery.
• One receiver controls one door.

Key features

• 433.92 MHz radio with a range of up to 30 m.
• Single relay controlling one door, with NO/NC/COM output to suit any lock wiring.
• The receiver learns up to 30 fobs.
• Jog, Latch and AB Latch modes, so the same unit can do momentary release or stay-unlocked duty.
• 12 V DC supply drawing only 8 mA.
• Receiver 41 x 39 x 27 mm, fob 57 x 32 x 11 mm, 0.06 kg.

What else you need

A 12 V DC supply at the door and a lock or controller for the relay to switch. Extra fobs if more than one person needs one, up to 30 per receiver.

Installation

An access control installer can fit it. The receiver is wired into the lock circuit or the controller’s exit input in the same way as a wired button, then each fob is learnt into the receiver and the mode (Jog, Latch or AB Latch) is set.

Before you buy

• One metal fob comes with the receiver; order more for extra users, up to 30.
• Not a substitute for a wired exit button and break glass unit on an escape route.